Ariens 45SB 用户手册

11 

30SB, 36SB, 45SB 

Snow BEAST 

 

 

Snow BEAST  Snow Blower 

V8.10.25.12 

Step 4: Chute Direction Control Cable Support 

With the rubber lined one hole strap removed, put 
the chute direction control cable and the chute 
deflector cable into the opening, and press the 
strap together aligning the hole for the bolt. 

Secure strap to side of the engine.   

NOTE:  Rotate discharge chute and ensure there is 
no binding of any cables and there is enough slack 
in the deflector cable for full rotation.

 

1.  The drift cutters are attached to the main housing in 

the stored position.   

2.  Remove the two bolts on each drift cutter. 

3. Reattach 

the 

drift cutters in the operating position. 

4.  Replace bolts and secure tightly. 

1.  Skid shoes are stored in the hardware bag for shipping.   

2.  Remove from hardware bag, and install skid shoes using the 

provided fasteners 

3.  Insert the fasteners so the flat head of the carriage bolt is 

toward the inside of the main housing. 

CAUTION:  Check the skids to ensure that the auger does 
not contact the paved or gravel surface.  Adjust skids as 
necessary to make up for wear on the snow blower. 

1.  Check the tire pressure to ensure the tires are properly 

inflated. 

2.  Move skid shoes up and down to the desired position based 

on the surface texture. 



If the surface is rougher adjust the skid shoes lower which 
increases the auger ground clearance. 



If the surfaces is smoother adjust the skid shoes higher 
(decrease ground clearance). Firmly tighten the nuts that 
secure both skids to the auger sides.