Ariens 45SB 用户手册

20 

30SB, 36SB, 45SB 

Snow BEAST 

 

 

Snow BEAST  Snow Blower 

V8.10.25.12 

If tension seems to be too loose or too tight the drive  
cables needs to be readjusted. 

 

1.  Loosen the bolt above where the cable screws in 

to the right side of the control panel. 

2.  Loosening the bolt enables the cable to screw in  

further, which makes the augers/impeller handle tight-
er. 

3.  Adjust the bolt and cable 

to the necessary  
adjustments. 

If tension seems to be too loose or too tight the  
augers/impeller cables needs to be readjusted. 

 

1.  Loosen the bolt above where the cable screws in 

to the left side of the control panel. 

2.  Loosening the bolt enables the cable to screw in fur-

ther, which makes the 
augers/impeller handle 
tighter. 

3.  Adjust the bolt and cable 

to the  
necessary adjustments. 

Adjusting Shift Rod 
 
The shift rod will be at a preset position from the 
factory, but after use, or maintenance, the shift rod 
may require occasional adjustment. 
 
Signs of adjustment need: 
1.  The shift handle is moved to the F1 position, and 

when the engagement handle is pressed, the unit 
does not move. 

2.  The shift handle is moved to the R1 position, and 

when the engagement handle is pressed, the unit 
does not move. 

 
If either of the above occur, it may be necessary to 
adjust using the following procedure: 
1.  Set the transmission handle to the space between F1 

and R1 as shown on the right. 

2.  Loosen the 2 nuts on the adjustment turnbuckle. 
3.  Remove the cover plate from the gearbox housing 

(see page 22).   

4.  Adjust the rod by turning the turnbuckle until the 

friction wheel aligns with the center of the circular 
disk in front of the rubber friction wheel.