Ariens 924332 1124 用户手册

GB - 22

Deflector must stay in selected position while 
throwing snow. 

To adjust, loosen then retighten hardware to 
desired deflector drag force (Figure 12).

Deflector must stay in selected position while 
throwing snow.
If deflector does not stay in set position: 

1. Tighten nut beneath the control panel to 

increase friction on pressure flange 
(Figure 13).

If deflector does not follow full range of travel:

1. Push deflector remote all the way 

forward.

2. Loosen adjusting nuts on cable support 

bracket.

3. To adjust the deflector lower:

Slide cable down. Tighten bottom nut.

4. To adjust deflector higher: 

Slide cable up. Tighten top nut.

5. Check travel and repeat adjustment as 

necessary.

If chute does not stay in position while 
operating, tighten nut on carriage bolt at pivot 
point to increase tension on spring (Figure 14).

Smooth and easy rotation of properly 
lubricated chute with crank is obtained by 
adjusting pinion and chute gear teeth so they 
mesh together. 

Runners should be adjusted (Figure 15) as 
conditions require.

1. Position unit on a hard, flat, smooth level 

surface. 

2. Adjust runners by inserting a spacer of 

desired thickness under center of scraper 
blade, loosen runner hardware, slide 
runners to flat surface. Allow 1/8 in. 
(3 mm) between scraper blade and hard 
smooth surfaces. Allow 1-1/4 in. (30 mm) 
between scraper blade and uneven or 
gravel surfaces. Retighten hardware.

WARNING: AVOID INJURY. Read 
and understand the entire Safety 
section before proceeding.

Figure 12

Adjusting Hardware

OS0113

Discharge Chute 
Deflector

Figure 13

1. Nut
2. Pressure Flange
3. Adjusting Nuts
4. Cable Support Bracket

OS0280

1

2

3

4

Figure 14

1. Pinion
2. Chute Gear
3. Carriage Bolt
4. Spring

DS0113

1

2

3

4