Husqvarna 96193006901 用户手册

12

NOTE: It is not recommended to operate the snow thrower 

over gravel or rocky surfaces. Objects such as gravel, rocks 

or other debris, can easily be picked up and thrown by the 

impeller, which can cause serious personal injury, property 

dam age or damage to the snow thrower. 
• 

If snow thrower must be operated over gravel surface, 

use extra caution and be sure skid plates are adjusted 

to lowest (highest scraper clear ance) position.

1.  Shut off engine and wait for all moving parts to stop.
2.  Adjust skid plates by loosening the 1/2" hex nuts, then 

moving skid plate to desired position. Be sure both 

plates are adjusted evenly. Tighten securely.

SCRAPER BAR (See Fig. 19)
The scraper bar is not adjustable, but is reversible.  After 

con sid er able use it may become worn.  When it has worn 

almost to the edge of the housing, it can be reversed, 

providing additional service before requiring replacement.  

Replace a dam aged or worn scrap er bar.

CHECK ENGINE OIL LEVEL (See Fig. 22)
The engine on your snow thrower has been shipped from 

the factory already filled with oil.
1.  Check engine oil with snow thrower on level ground.
2.  Remove oil fill cap/dipstick and wipe clean, reinsert 

the dipstick and screw tight, wait for a few seconds, 

remove and read oil level. If necessary, add oil until 

“FULL” mark on dipstick is reached. Do not overfill.

• 

To change engine oil, see “TO CHANGE ENGINE OIL” 

in the Main te nance sec tion of this manual.

TO USE DRIFT CUTTERS (See Fig. 20)
Use the drift cutters to cut through deep snowdrifts that are 

higher than the front of the snow thrower.
• 

Loosen adjustment nuts enough to allow drift cutter to 

be raised to highest position and tighten nuts securely. 

Repeat for opposite side of snow thrower.

•  When not using drift cutters, loosen adjustment nuts, 

lower to storage position and tighten nuts securely.

TO TRANSPORT (See Fig. 21)
When pushing or towing your snowthrower, be sure to 

disengage transmission by placing freewheel control into 

FREE WHEEL po si tion.  Freewheel control is located at the 

rear of snowthrower.
•  Pull freewheel control out to FREEWHEEL position.
•  To reengage transmission, push control back in.

ADD GASOLINE (See Fig. 22)
• 

Fill fuel tank to bottom of tank filler neck.  Do not over-

fill.  Use fresh, clean, regular unleaded gasoline with 

a minimum of 87 octane.  Do not mix oil with gasoline.  

Purchase fuel in quan ti ties that can be used within 30 

days to assure fuel freshness.