Husqvarna 96193004400 用户手册

6

INSTALL AUGER CONTROL ROD (See Figs. 5 and 6)
The auger control rod has the short loop on the end of the 

spring as shown.
1.  Slide rubber sleeve up rod and hook end of spring into 

control arm with loop opening up as shown.

2.  With top end of rod positioned under right side of 

control panel, push down on rod and insert end of rod 

into hole in auger control bracket.  Secure with retainer 

spring.

HEAD (See Fig. 7)
NOTE: The multi-wrench provided in your parts bag may 

be used to install the chute rotator head.
1.  Place discharge chute assembly on top of chute base 

with discharge opening toward front of snow thrower.

2.  Position chute rotator head over chute bracket.  If nec es-

 sary, rotate chute assembly to align square and pin on un-

 der side of chute rotator head with holes in chute brack et.

3.  With chute rotator head and chute bracket aligned, 

po si tion chute rotator head on pin and threaded stud 

of mounting bracket.

4.  Install 3/8 washer and locknut on threaded stud and 

tighten securely.

ALIGN BEFORE

TIGHTENING LOCKNUT