Husqvarna 96193006600 用户手册

19

TO ADJUST CABLE TENSION (See Fig. 26)
Adjust cable tension by turning the adjuster turn buckle, 

located on the right hand cable.  Grasp the long section 

tightly and turn the short section to lengthen the adjuster.  

Adjust until cable is snug.

TO REMOVE WHEELS (See Fig. 25)
•  Remove the klik pin and remove wheel from axle.
IMPORTANT: When installing wheel, be sure to use the 

axle hole closest to the end of the shaft – do not use the 

hole in the wheel hub (if equipped).  Inner hole in axle and 

hole in wheel hub are not used for your model snow thrower.
NOTE: To seal punctures or prevent flat tires due to slow 

leaks, tire sealant may be purchased from your local parts 

dealer. Tire sealant also prevents tire dry rot and cor ro sion.

ENGINE
SEE ENGINE MANUAL.

CARBURETOR
Your carburetor is not adjustable. Engine performance 

should not be affected at altitudes up to 2,134 meters. If 

your engine does not operate properly due to suspected 

carburetor problems, take your snow thrower to a service 

center/department.
ENGINE SPEED
Never tamper with the engine governor, which is factory set 

for proper engine speed. Overspeeding the engine above 

the factory high speed setting can be dangerous and will 

void the warranty. If you think the engine-governed high 

speed needs adjusting, contact a service center/depart-

ment, which has the proper equipment and experience to 

make any necessary ad just ments.