Troy-Bilt 7524 用户手册

9

The auger control is located on the left handle. 
Squeeze the control grip against the handle to engage 
the augers and start snow throwing action. Release to 
stop.

The drive control is located on the right handle. 
Squeeze the control grip against the handle to engage 
the wheel drive. Release to stop. 

The chute directional control is located on the left side 
of the dash panel.

•

To change the direction in which snow is thrown, 
squeeze the button on the joy-stick and pivot the 
joy-stick to the right or to the left.

•

To change the angle/distance which snow is 
thrown, pivot the joy-stick forward or backward.

The ignition key is a safety devise. It must be fully 
inserted in order for the engine to start. Remove the 
ignition key when the snow thrower is not in use.

Never use your hands to clear 

a clogged chute assembly. Shut off engine 
and remain behind handles until all moving 
parts have stopped before unclogging.

The chute clean-out tool is fastened to the top of the 
auger housing with a mounting clip. The tool is 
designed to clear a clogged chute assembly. Refer to 
Operating Your Snow Thrower section for more detailed 
information regarding the chute clean-out tool.

Position the skid shoes based on surface conditions. 
Adjust upward for hard-packed snow. Adjust downward 
when operating on gravel or crushed rock surfaces.

This handle is used to manually start the engine.

Pressing the electric starter button engages the 
engine’s electric starter when plugged into a 120V 
power source.

Requires the use of a three-prong outdoor extension 
cord and a 120V power source/wall outlet.

When engaged, the augers rotate and draw snow into 
the auger housing.

Snow drawn into the auger housing is discharged out 
the chute assembly.

Unscrew 1/4-turn to access the spark plug and spark 
plug wire.