White Outdoor 9235 用户手册

NOTE:  This Operator’s Manual covers several models. 
Snow thrower features vary by model. Not all features 
discussed in this manual are applicable to all snow 
thrower models.

NOTE:  All references to left or right side of the snow 
thrower is from the operating position only

Carton contents are listed below with part numbers in 
parentheses.
1.  Two Ignition Keys (725-0201)
2.  2.6 oz Bottle of 2 Cycle Oil (737-04037)
3.  Extension Cord (if so equipped) (629-0236)

Remove packing material, if present. 
1.  Making sure not to pinch the cable in the process, 

pivot the upper handle into the operating position as 
illustrated in Figure 3-1 until it clicks into place.

2.  Tighten the wing knobs to secure the handle in place 

as in Figure 3-1.

For shipping reasons, the snow thrower has been 
packaged with the upper chute pivoted all the way down. 
To pivot it upward, proceed as follows: 
1.  Turn the chute until the chute opening is facing 

straight ahead.  Remove the star knob and carriage 
bolt from the lower chute.  See Figure 3-2.

2.  Pivot the upper chute upward over the lip on the lower 

chute so that there is NO gap between the upper 
chute and the lower chute.

3.  Resecure with the hardware just removed.  If installed 

correctly, your snow thrower should look like Figure 
3-3.

IMPORTANT:  Do not use the chute handle to lift the 
snow thrower.

NOTE: 

This Operator’s Manual 

covers several models. 

Snow thrower features 

vary by model. Not 

all features discussed 

in this manual are 

applicable to all snow 

thrower models.

NOTE:

All references to left 

or right side of the 

snow thrower is 

from the operating 

position only.

Do not use the 

chute handle to lift  

the snow thrower.

Chute Handle

2

3

1

1

2