White Outdoor 750T 用户手册

5

•

Remove screws from the top sides and ends of the 
shipping crate.

•

Set panel aside to avoid tire punctures or personal 
injury.

•

Remove and discard plastic bag that covers unit.

•

Remove any loose parts included with unit (i.e., 
Operator’s Manual, etc).

•

Roll unit out of crate.

The augers are secured to the auger shaft with two 
shear bolts and hex lock nuts. If you hit a foreign object 
or ice jam, the snow thrower is designed so that the 
bolts may shear. Two replacement shear bolts and nuts 
are provided for your convenience. Store in a safe 
place until needed. See Figure 1.

•

Remove the lower two plastic wing knobs, cupped 
washers and carriage bolt (eyebolt on the left side) 
from the lower handle. See Figure 2.

•

Raise the upper handle assembly until it locks over 
the lower handle. 

•

Look at the lower rear of snow thrower frame to be 
sure both cables are aligned with cable roller 
guides.

•

Secure the upper handle and lower handle with the 
two plastic wing knobs, cupped washers and 
carriage bolt (eyebolt on the left side) previously 
removed. See Figure 3.

•

Adjust the eyebolt on the chute directional control 
so the rod does nut come into contact with the 
engine by moving the hex nut against the handle (if 
necessary). Retighten the wing nut to secure the 
directional control in this position.  

•

Slide the shift rod connector down over the end of 
the lower shift rod. Tap the connector until it locks 
on the lower shift rod. See Figure 3.

•

If not already attached, slip the cables that run from 
the handle panel to the chute into the cable guide 
located on top of the engine. See Figure 4.

•

Unwrap the headlight wire, which is attached to the 
headlight beneath the handle panel.

•

Wind the headlight wire around the right handle 
until excess slack is removed.