Multiquip DA700SSW 用户手册

17.  Fuel drain Plug — Remove this plug to drain fuel 

from the fuel tank.

18.  Frame Ground Lug — Connect a ground strap 

between this lug and a ground rod. Make sure that the 
ground rod is inserted deep into the ground to provide 
a good earth ground. Consult with local Electrical and 
Safety Codes for proper connection.

19.  CS6369 Receptacle — Dual voltage receptacle, 

provides 120/240 volts output at 25 amps.

20.  L-14-30R Receptacle — Dual voltage receptacle, 

provides 120/240 volts output at 25 amps.

21.  L5-30R Receptacle — Provides 120 volts output at 

25 amps.

22.  Receptacle  G.F.C.I. — This receptacle provides 120 

volts output at 20 amps.

23.  GFCI Circuit Breaker — This single pole circuit 

breaker provides circuit protection (120V @20 amps) 
for the G.F.C.I receptacle.

24.  Main Circuit Breaker — This 2-pole circuit breaker 

provides circuit protection (265V @25 amps) for the 
Electric Parts Assembly.

25.  AC Voltmeter — This voltmeter indicates (with a 

mark) the rated 60 Hz (single-phase) output voltage. 
In addition the voltmeter can also be used as a 
diagnostic tool. If the voltmeter indicator (needle) is 

below the rated voltage, engine problems may exist 
(low/high RPM's). To prevent damage to the generator 
or power tools turn the generator OFF and consult your 
authorized Multiquip service dealer.

26.  Hour Meter —  Indicates number of hours machine 

has been in use or hours engine was run.

27.  Idle Control Switch — The generator is provided with 

an automatic idle control device for noise suppression 
and reduced fuel consumption.

The automatic idle control automatically engages under 
a no-load condition. With the automatic idle control 
switched “ON”, the engine revolutions will automatically 
drop to about 2200 rpm (low-speed operation) within 
3 seconds after the load stops. When the operation is 
resumed, the engine speed is automatically increased 
to about 3600 rpm (high-speed operation) as soon as 
the load is connected.

28.  Warning Lamp Display — Lights red when the 

following conditions occur:

 Oil Pressure Lamp — If the oil pressure drops 

suddenly, the oil pressure lamp will go on, and 
the generator will shut down.

 Charge Lamp — The charge lamp will go 

on when the battery fails to charge, and the 
generator will shut down.

 Water Temperature  Lamp  — The water 

temperature lamp will go on if the temperature 
rises to an abnormally high level, and the 
generator will shut down.

29.  Starter Switch — With key inserted turn clockwise to 

start engine.

30.  Oil Filter — Provides oil fi ltering for the engine.

This  KUBOTA engine is equipped with a low oil 
shutdown capability. A built in sensor will automatically 
turn off the engine should the oil level fall below a safe 
operating condition. Make sure the generator is placed 
on level ground. Placing the generator on level ground 
will ensure that the low oil sensor will function properly.