Teledyne 751H 用户手册
07773A DCN6833
13
3
GETTING STARTED
This section provides instructions on the proper installation and power up of the
751H. Refer to Figure 4-2 for the instrument layout and Table 2-1 for the
specifications.
751H. Refer to Figure 4-2 for the instrument layout and Table 2-1 for the
specifications.
NOTE
Due to mounting screws through its case, the 751H is not considered waterproof.
3.1 Unpacking
CAUTION
TO AVOID PERSONAL INJURY, ALWAYS USE TWO PERSONS TO
LIFT AND CARRY THE 751H.
LIFT AND CARRY THE 751H.
1. Remove the 751H from its shipping carton.
2. Verify that there is no shipping damage. If there are signs of damage, immediately
2. Verify that there is no shipping damage. If there are signs of damage, immediately
advise the shipper, then Teledyne API.
3. Open the lid and check for damage inside.
4. Check the line voltage and frequency label on the instrument to ensure that it
4. Check the line voltage and frequency label on the instrument to ensure that it
matches the local power source.
3.2 Installation
The basic 751H is a portable, self-contained instrument; there are no installation
instructions other than to ensure adequate support for its weight. However, the
connections must be made to the instrument panel and drain port with the lid open
(see Section 3.4 for connection instructions).
instructions other than to ensure adequate support for its weight. However, the
connections must be made to the instrument panel and drain port with the lid open
(see Section 3.4 for connection instructions).
CAUTION
TO AVOID PERSONAL INJURY OR DAMAGE TO THE INSTRUMENT,
ALWAYS OPERATE THE 751H WITH THE LID OPEN.
ALWAYS OPERATE THE 751H WITH THE LID OPEN.