Generac Power Systems 004701-0 用户手册

 10 

After the 25-hour break-in period, contact an 
Authorized Service Dealer for the following main-
tenance. The vehicle owner is responsible for any 
charges:

•  Change the engine crankcase oil and oil filter.
•  Check the oil level.
•  Inspect the cooling and ventilation openings.
•  Check the engine carburetor adjustments.
•  Check the engine ignition system.
•  Inspect the entire electrical system.
•  Inspect the engine exhaust system.

If the recreational vehicle generator has been sub-
merged in water, it MUST NOT be started and oper-
ated. Following any submersion in water, have an 
Authorized Service Dealer thoroughly clean and dry 
the generator.

Never operate the generator while the vehicle is 
parked over high grass, weeds, brush, leaves or any 
other combustible substance. Such materials can 
ignite and burn from the heat of the exhaust system. 
The generator exhaust system becomes extremely 
hot during operation and remains hot for a long time 
after it has shut down.

‹

‹

‹

Keep the generator set as clean and dry as possible.  
Protect the unit against excessive dust, dirt, cor-
rosive vapors, road splash, etc. Permitting dirt and 
moisture to accumulate on generator windings will 
have an adverse effect on the insulation resistance of 
those windings.

When moisture is allowed to remain in contact with 
windings, some of the moisture will be retained in 
voids and cracks in the insulation. This causes a 
reduced insulation resistance and will eventually 
cause problems. Dirt will make the problem worse, 
since dirt tends to hold moisture in contact with 
windings. Salt (as from sea air) also will worsen the 
problem since it tends to absorb moisture from the 
air. Salt and moisture, when combined, form a good 
electrical conductor.

For oil capacities and requirements, see “Engine Oil 
Requirements” section. Check the engine crankcase 
oil level at least every eight hours of operation, or 
before using it. To check the engine oil level, proceed 
as follows (see Figure 3.1):

1.  Be sure the generator is as level as possible.
2.  Remove the dipstick and wipe it dry with a clean, 

lint-free cloth.

3.  Install and tighten the dipstick cap; then, remove 

it again. The oil level should be at the dipstick 
“Full” mark.

‹

GENERAC OHVI INDUSTRIAL ENGINE

I

t

r

e

,

e

h it

w a

n c . -

s

m

, I

e

W

           POWERED

W

y s

S

r

o

P

w e

A C

N

R

E

G E

OHVI

t

GENERAC

TM

RV SERVICE LOCATOR:

1.800.333.1322

QUIETPACT 40G

*

S E R V IC E

A C C E S S

P A N E L

OIL LEVEL:

CHECK DAILY

AIR FILTER:

CLEAN PREFILTER
EVERY 100 HOURS.
REPLACE ELEMENT
EVERY 250 HOURS.

OIL & OIL FILTER:

CHANGE EVERY 100

(IF NECESSARY)

EVERY 500 HOURS.

HOURS. REPLACE PLUGS

PLUGS EVERY 100

INSPECT & CLEAN

SPARK PLUGS:

REPLACEMENT INFORMATION

*

PERFORM MORE OFTEN IN DUSTY CONDITIONS

AIR FILTER LOCATED BEHIND PANEL.

MAINTENANCE SCHEDULE

AIR FILTER P/N:

0D3262

070185

OIL FILTER P/N:

SPARK PLUG P/N:

072347

OIL CAPACITY WITH FILTER:

0.8L/0.84QT

TEMPERATURE

SAE VISCOSITY

32˚F AND HIGHER

10˚F TO 100˚F

0˚F TO 80˚F

-20˚F TO 50˚F

5W-30

10W-30

15W-40

30

WHEN SERVICE OR PARTS ARE NEEDED IN

THE USA OR CANADA, CONTACT THE GENERAC

SERVICE LOCATOR AT 1-800-333-1322.

HOURS. (OR ANNUALLY)

PREFILTER P/N:

0D4511

FUEL FILTER P/N:

0D7515

FUEL FILTER:

CHANGE EVERY 400
HOURS. (OR ANNUALLY)

*

*

P R I M E

F U E L

S T O P

S T A R T

3 0 A

C . B .

A

F U S E

CONTROL CENTER

7.5

To Re

m

o

v

e

Oil Dipstick/Oil Fill

Oil Drain

Oil Filter