Samson CL2 用户手册

6

The CL2 can be mounted to any standard microphone stand using the included mic 

clip or shock-mounts . Be aware of a phenomenon called the proximity effect which 

causes a noticeable increase in low frequencies (bass response) when a microphone 

is close to the audio source. This can have positive impact—for example, it will cause 

your instrument or voice to sound much fuller when you sing close to the mic than 

when you mic it at a distance. The key to developing the best mic technique is experi-

mentation, along with awareness of the general principle that, the closer your CL2 is to 

a signal source, the greater the bass response.

The CL2 matched kit comes with two shock-

mounts, which you can use to greatly reduce 

any noise transmitted through the mic stand. 

The shockmounts are especial useful in 

reducing the problems caused by a boomy 

soundstage, for example when miking 

overhead cymbals, or even in the studio with 

talent that likes to move a lot on a floor that 

may not be a solid as it should be.

•   To use the CL2 with their included 

shockmounts, screw the shockmount on 

a standard mic stand. If you are using a US 

standard 5/8-inch mic stand, remove the 

Euro adapter by unscrewing it from the 

shockmount.

•   Once the shockmount is mounted to the 

stand, carefully slide the CL2 through the 

elastic bands of the shockmount. 

•   Use the thumb screw to set the micro-

phone angle.