Roland PCR-30 用户手册
145
Edit mode (EDIT)
13. To specify “2” for the upper bits, press the
[2]
key.
The display will indicate “2BL”.
14. Confirm what’s indicated and press
[ENTER]
.
15. In the same way, enter bytes 8.
16. Since the ninth byte is the data area, press the
[DATA]
key.
The display will indicate “DT0.”
17. Confirm what’s indicated and press
[ENTER]
.
18. Since the ten byte will contain the checksum, press the
[CHECKSUM]
key to specify the location at which the
checksum will be input.
The display will blink “CS1” (Checksum Type 1).
The display will blink “CS1” (Checksum Type 1).
19. Confirm what’s indicated and press
[ENTER]
.
20. Press the
[F]
and then
[7]
keys to input the ending status “F7.”
21. Confirm what’s indicated and press
[ENTER]
.
22. Next, specify an upper limit value of “58” for the data area.
23. Press
[ENTER]
.
24. Specify a lower limit value of “40” for the data area.
25. Press
[ENTER]
.
26. Specify the output port.
(➔
27. If you are making an assignment for a button, specify the button mode. (➔
The GS Bend Pitch Control message has been assigned.