Roland pt-2700 用户手册

Connecting to MIDI Devices

Turning Transmission and
Reception of Control
Changes On/Off

Messages known as “Control Changes” are used to convey to

another device information about the instances where you

have pressed a pedal, or have turned On/Off the Chorus or

Reverb effects.

Each time the power is turned on, the instrument will always

be set to “On” (it will transmit/receive all Control Change

messages).

If you set it to “Off” the pt-2700 will no longer send or

receive any Control Change messages.

While holding down the [GRAND PIANO]
button, [UPRIGHT PIANO] button, and
[STRINGS] button, press the “A5” note to
turn the setting On, or the “B5” note to turn
the setting Off.

fig.8-12.e

If you want to know more about Control Change Number,

please refer to “MIDI Implementation Chart” (p. 39).

Transmitting Performance
Data from MIDI Out

If this setting is left “On,” performance data recorded on the

pt-2700 can be transmitted from the MIDI Out connector.

Each time the power is turned on, this setting will always be

at “Off.”

Hold down the [GRAND PIANO] button, the
[UPRIGHT PIANO] button, and the
[STRINGS] button, and press the “D6” note
to turn the setting On, or the “E6” note to
turn the setting Off.

fig.8-13.e

The performance data that you recorded will disappear

when the power of the pt-2700 is turned off.

If you wish to save the performance, use the following
procedure.

1. Connect a MIDI sequencer such as the MT

series (p. 31).

2. Record the performance on the pt-2700

(p. 22).

3. Set this setting to “On.”

4. Start recording with the connected MIDI

device.

5. Start playback of the recorded song on the

pt-2700.

6. When playback ends, stop recording with

the connected MIDI device.

7. Use a connected MIDI sequencer to save

the data on a floppy disk or other media.

Off