Roland V-Synth 用户手册
60
Creating and Editing Samples (Sample Mode)
Deleting a Sample (SAMPLE Delete)
1.
2.
Touch <
▼
> in the upper right of the screen.
A pulldown menu appears.
fig.04-03_50
3.
In the pulldown menu, touch <SAMPLE Delete>.
The SAMPLE Delete List window appears.
fig.04-04d_50
4.
From the list, select the sample that you want to delete.
Either turn the VALUE dial or use [INC/+][DEC/-] to select a
patch. You can also select a patch by touching it on the display.
patch. You can also select a patch by touching it on the display.
Each screen in the SAMPLE Delete List window shows a group
of 16 samples. To view other samples, touch <017-032>–<241-
256>, located at either side of the screen. To view higher-
numbered samples, touch <257-512>–<769-999>, located at the
bottom of the screen.
of 16 samples. To view other samples, touch <017-032>–<241-
256>, located at either side of the screen. To view higher-
numbered samples, touch <257-512>–<769-999>, located at the
bottom of the screen.
5.
Touch <Execute>.
The selected sample will be deleted.
6.
If you want to continue deleting other samples, repeat steps
4 and 5.
7.
Press [EXIT].
The SAMPLE Delete List window closes.
Resampling
The V-Synth is able to resample samples from its internal memory.
This is called
This is called
resampling
. In actuality, the sounds that are output
from the rear panel MAIN OUT L(MONO), R jacks are sampled.
For example, you could sample multiple samples played
simultaneously, and record them as a single sample. You can
conserve voices in this way.
simultaneously, and record them as a single sample. You can
conserve voices in this way.
fig.04-05.e
Before you enter Resampling mode, make settings so that you can
play the sample(s) you wish to resample.
play the sample(s) you wish to resample.
The resampling procedure is essentially the same as the “Sampling
Procedure” described in the preceding section. However, please be
aware of the following points.
Procedure” described in the preceding section. However, please be
aware of the following points.
• You must set the Input Source in the SAMPLING General screen
to “RESAMPL.”
Setup Settings
SAMPLING General
fig.04-06_50
Sampling Type
Select the type of sampling.
Value
STEREO L R:
Sample in stereo.
MONORAL MIX:
Mix the signals input to L and R, and sample in
monaural.
MONORAL L:
Sample the L input signal in monaural.
MONORAL R:
Sample the R input signal in monaural.
Pre-FX
Effect
OUTPUT
INPUT
Pre Gain
Sampling
Sound
Generator