Roland TD-6 用户手册

Make the settings for each drum kit.

If this lights, press [CLICK] to extinguish it.

[KIT] and [EDIT] light.

fig.KIT-CMN_50

fig.01-046ai.e

fig.01-047ai.e

You can adjust the overall volume of the drum kit while 
preserving the volume balance between each of the pads. The 
higher the value is set, the greater the volume. With a setting 
of “0,” no sound is produced.

The volume balance among the pads is adjusted in the “Level” 
(KIT/INST/Level; p. 61).

fig.01-048_50

For each drum kit, you can adjust the volume of the pedal hi-
hat that sound (when the hi-hat control pedal is pressed). The 
higher the value is set, the greater the volume. With a setting 
of “0,” no sound is produced.

Set the volume level of other pads with the “Level” setting 
(KIT/INST/Level; p. 61).

fig.01-049_50 (KIT-COMMON-Pedal-Hat) 

Pitch Control is a function that lets you change the pitch of an 
instrument assigned to a pad according to the amount the hi-
hat control pedal is pressed.

Releasing the pedal returns the instrument to its original pitch.

The degree to which the pitch is to change when the hi-hat 
control pedal is pressed is set in semitone (half-step) 
increments from -24 (down two octaves) to +24 (up two 
octaves). When set to “0,” there is no change in pitch.

Pitch Control is turned on and off in the “Pitch Ctrl (Pitch 
Control)” setting (KIT/CONTROL/Pitch Ctrl; p. 66).

• To prevent the pedal hi-hat sound from being played 

when the hi-hat pedal is pressed, set “Pedal HH Vol 
(Pedal Hi-Hat Volume)” to “0” (KIT/COMMON/Pedal 
HH Vol; p. 68).

• To have changes in pitch occur smoothly, set 

“PdlDataThin (Pedal Data Thin)” to “1” or “OFF” 
(SETUP/MIDI COMMON/PdlDataThin; p. 99).

fig.01-050_50

Parameter to set

Value