Roland VS-1680 用户手册

Editing an automix

As part of the new software, select the area to edit. You can

now select an area (marker), and edit the automix data in that

area. To edit the automix data, you must first select the area

to which your editing will apply.

Erasing data from a specific
area (Erase)

This operation erases the automix data from a specific area.

Markers will not be erased.

fig.4-01.e

NOTE

Editing of the automix data cannot be cancelled by the Undo

function (VS-1680 Owner’s Manual, p. 160).

1. Press [PLAY (DISPLAY)].

2. Hold down [SHIFT] and press [F6 (UTIL)].

3. Press [PAGE] so that [F5] indicates “A.Mix,” and then

press [F5 (A.Mix)].

fig.4-02

4. Press [F2 (Micro)].

5. Press [PAGE] so that [F1] indicates “In.”

fig.4-03

6. Make sure that the cursor is located at “Edit Target,” and

use the TIME/VALUE dial to select the automix data

that you wish to erase.

7. Use [

][

] to move to the first marker of the area

from which you wish to erase automix data, and press

[F1 (In)].

8. Use [

][

] to move to the last marker of the area

from which you wish to erase automix value, and press

[F1 (Out)]. Check marks will be added to the area

specified for erasure.

fig.4-04.e

NOTE

Even if you wish to erase the automix data for only one marker,

press the button in the order of [F1 (In)]

→

[F1 (Out)] at the same

marker location.

MEMO

You can rotate the TIME/VALUE dial to modify the automix

setting value at the cursor location. If you wish to re-select

the automix value that will be erased, press [

9. Press [F2 (Erase)].

0 M0

Time

0 M0

Time

Check marks