Roland XV-5080. 用户手册

Three different Multi-effects can be used in a Performance.

Select which of these three Multi-effects to use with Part 
Output MFX Select. With this parameter, the same Multi-
effects are applied to all selected Parts. You can adjust the 
amount of effect to be applied to the Parts by adjusting their 
Send Levels to each of the effect units. (Fig. 1)

The Send Level setting for each Tone can also influence effect 
intensity (Fig. 2).

Furthermore, you can take the Multi-effects you have applied 
to a Patch in a Part and apply them to the entire 
Performance, or just part of the Performance.

fig.02-012.e

fig.02-013.e

The primary role of the effect settings is to determine the Part 
Output Assign.

You can select from the following Part Output Assign 
settings values to suit your purposes.

 Selected when Multi-effects, chorus, and reverb are 

used.

 Selected when outputting in stereo without use of the 

Multi-effects. Chorus and reverb can be used.

 Selected when outputting in mono without Multi-

effects. Chorus and reverb can be used. When this setting is 

used, chorus and reverb sounds are output in stereo 
according to the Chorus Output Assign and Reverb Output 
Assign settings.

 The Part’s output destination is determined by the 

settings of the Patch or Rhythm Set assigned to the Part. 

The screen appears as shown below, according to the settings 
values.

• For MFX

fig.02-014.e_70

• For A–D

fig.02-015.e_70

• For 1–8

fig.02-016.e_70

1. Select the Performance you wish to use.

2. Press [F5 (Effects)].

The Perform Effect page will appear.

3. Press [F1 (General)].

The General page will appear.

fig.02-017.e_70

4. Press [

]/[

]/[

]/[

] to move the cursor to 

the parameter you want to set.

5. Turn the VALUE dial, or press [INC]/[DEC] to select the 

desired value.

6. Repeat Steps 3 to 5 to set the Effect.

7. Press [EXIT] to return to the PERFORM Play page.