Roland RD-700 用户手册
18
Getting Ready
Getting Ready
Checking the Installed Wave Expansion Boards
After installation of the Wave Expansion Boards has been completed, check
to confirm that the installed boards are being recognized correctly.
to confirm that the installed boards are being recognized correctly.
fig.panel
1
2
Hold down EXPANSION [A] or [B] for several seconds.
The name of the installed wave expansion board appears in the display.
fig.LCD
The example here depicts what you would see if the SRX-02 “Concert
Piano” Wave Expansion Board were installed in the SRX A slot.
Piano” Wave Expansion Board were installed in the SRX A slot.
By releasing the button, you go back to the previous screen.
CONTROL
2
NOTE
If “—————-” appears
next to the name of the slot
in which the board was
installed, it may be that the
wave expansion board is
not being recognized
properly. Use the
procedure in “Turning Off
the Power”
next to the name of the slot
in which the board was
installed, it may be that the
wave expansion board is
not being recognized
properly. Use the
procedure in “Turning Off
the Power”
the power off, then reinstall
the wave expansion board
correctly.
the wave expansion board
correctly.
RD-700_e.book 18 ページ 2004年4月26日 月曜日 午前11時54分