Roland TD-20K 用户手册

 

Assemble the Drum Stand.

 

About the Stand, refer to the MDS-20 Owner’s Manual.

• Do NOT open the legs of the stand more than 135 

degrees. The distance between the back Right/Left end 
legs should NOT be more than 2 m (80 inches), otherwise, 
the cable (inside the Pipes) could be damaged and/or the 
stand could tip over.

 

fig.01.e

 

• Do NOT loosen any bolts other than Hand Knobs except 

when changing the parts or cables for repairing.

Attach the stand holder (included with the drum stand MDS-
20) to the TD-20.

Using the screws attached to the bottom panel, attach the 
holder so the unit is oriented as shown in the diagram.

 

fig.02.e

 

• To attach the stand holder, remove the four 12 mm 

screws (M5 x 12) from the bottom of the TD-20 and use 
them. Use of other screws may result in damage to the 
unit.

 

928

 

• When turning the unit upside-down, get a bunch of 

newspapers or magazines, and place them under the four 
corners or at both ends to prevent damage to the buttons 
and controls. Also, you should try to orient the unit so no 
buttons or controls get damaged.

 

929

 

• When turning the unit upside-down, handle with care to 

avoid dropping it, or allowing it to fall or tip over.

Mount the VH-12 on a commercially available hi-hat stand.

 

Refer to the VH-12 Owner’s Manual.

After the VH-12 is connected to the TD-20 percussion sound 
module, the 

 

 must be adjusted. For details, read the 

instructions in the TD-20 and VH-12 Owner’s Manuals.

135˚

135˚

2 m

Narrow

Wide

TD-20K_e.book 4 ページ ２００６年１２月７日　木曜日　午前９時２４分