Roland TD-6V 用户手册

 

 

 

To resize thickness, move all items on the front cover to left or right

  

IMPORTANT: THE WIRES IN THIS MAINS LEAD ARE COLOURED IN ACCORDANCE WITH THE FOLLOWING CODE.

BLUE: 
BROWN: 

As the colours of the wires in the mains lead of this apparatus may not correspond with the coloured markings identifying 
the terminals in your plug, proceed as follows:
The wire which is coloured BLUE must be connected to the terminal which is marked with the letter N or coloured BLACK.
The wire which is coloured BROWN must be connected to the terminal which is marked with the letter L or coloured RED.
Under no circumstances must either of the above wires be connected to the earth terminal of a three pin plug.

NEUTRAL
LIVE

  

This product complies with the requirements of European Directive 89/336/EEC.

Lithiumbatteri - Eksplosionsfare ved 
fejlagtig håndtering.
Udskiftning må kun ske med batteri af
samme fabrikat og type.
Levér det brugte batteri tilbage til 
leverandøren.

Explosionsfara vid felaktigt batteribyte.
Använd samma batterityp eller en 
ekvivalent typ som rekommenderas av 
apparattillverkaren.
Kassera använt batteri enligt 
fabrikantens instruktion.

Danger of explosion if battery is 
incorrectly replaced.
Replace only with the same or 
equivalent type recommended by the 
manufacturer.
Discard used batteries according to the 
manufacturer’s instructions.

Eksplosjonsfare ved feilaktig skifte av 
batteri.
Benytt samme batteritype eller en 
tilsvarende type anbefalt av 
apparatfabrikanten.
Brukte batterier kasseres i henhold til 
fabrikantens instruks joner.

Paristo voi räjähtää, jos se on
virheellisesti asennettu.
Vaihda paristo ainoastaan 
laitevalmistajan suosittelemaan 
tyyppiin. Hävitä käytetty paristo 
valmistajan ohjeiden mukaisesti.

This Class B digital apparatus meets all requirements of the Canadian Interference-Causing Equipment Regulations.

Cet appareil numérique de la classe B respecte toutes les exigences du Règlement sur le matériel brouilleur du  Canada.

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the 
FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential 
installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in 
accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee 
that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or 
television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the 
interference by one or more of the following measures:

–   Reorient or relocate the receiving antenna.
–   Increase the separation between the equipment and receiver.
–   Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
–   Consult the dealer or an experienced radio/TV technician for help.

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
 (1) This device may not cause harmful interference, and
 (2) This device must accept any interference received, including interference that may cause undesired operation.

Unauthorized changes or modification to this system can void the users authority to operate this equipment.
This equipment requires shielded interface cables in order to meet FCC class B Limit.

 

001

 

• Before using this unit, make sure to read the 

instructions below, and the Owner’s Manual.

 

................................................................................................

 

002c

 

• Do not open (or modify in any way) the unit or its 

AC adaptor.

 

................................................................................................

 

003

 

• Do not attempt to repair the unit, or replace parts 

within it (except when this manual provides 
specific instructions directing you to do so). Refer 
all servicing to your retailer, the nearest Roland 
Service Center, or an authorized Roland distributor, 
as listed on the attached “Information” leaflet.

 

................................................................................................

 

004

 

• Never use or store the unit in places that are:

• Subject to temperature extremes (e.g., direct 

sunlight in an enclosed vehicle, near a heating 
duct, on top of heat-generating equipment); or 
are

• Damp (e.g., baths, washrooms, on wet floors); or 

are

• Humid; or are
• Exposed to rain; or are
• Dusty; or are
• Subject to high levels of vibration.

 

................................................................................................

 

005

 

• This unit should be used only with a rack or stand 

that is recommended by Roland.

 

................................................................................................

 

006

 

• When using the unit with a rack or stand recom-

mended by Roland, the rack or stand must be 
carefully placed so it is level and sure to remain 
stable. If not using a rack or stand, you still need to 
make sure that any location you choose for placing 
the unit provides a level surface that will properly 
support the unit, and keep it from wobbling.

 

................................................................................................

 

008c

 

• Be sure to use only the AC adaptor supplied with 

the unit. Also, make sure the line voltage at the 
installation matches the input voltage specified on 
the AC adaptor’s body. Other AC adaptors may 
use a different polarity, or be designed for a 
different voltage, so their use could result in 
damage, malfunction, or electric shock.

 

................................................................................................

 

009

 

• Do not excessively twist or bend the power cord, 

nor place heavy objects on it. Doing so can damage 
the cord, producing severed elements and short 
circuits. Damaged cords are fire and shock hazards!

 

................................................................................................

Used for instructions intended to alert 
the user to the risk of injury or material 
damage should the unit be used 
improperly. 

* Material damage refers to damage or 

other adverse effects caused with 
respect to the home and all its 
furnishings, as well to domestic 
animals or pets. 

Used for instructions intended to alert 
the user to the risk of death or severe 
injury should the unit be used 
improperly. 

The 

●

  symbol alerts the user to things that must be 

carried out. The specific thing that must be done is 
indicated by the design contained within the circle. In 
the case of the symbol at left, it means that the power-
cord plug must be unplugged from the outlet. 

The      symbol alerts the user to important instructions 
or warnings.The specific meaning of the symbol is 
determined by the design contained within the 
triangle. In the case of the symbol at left, it is used for 
general cautions, warnings, or alerts to danger. 

The       symbol alerts the user to items that must never 
be carried out (are forbidden). The specific thing that 
must not be done is indicated by the design contained 
within the circle. In the case of the symbol at left, it 
means that the unit must never be disassembled.