Roland SP-606 用户手册
26
Quick Start
5.
6.
Hold down [FUNC] and press the [INPUT SOURCE] pad to get the
INPUT SETTING screen.
INPUT SETTING screen.
7.
Turn the VALUE dial or use [DEC][INC] to set “Input Select” as
follows.
follows.
If you made connections to
INPUT L/R
in step 3:
LINE
If you made connections to
DIGITAL IN
in step 3:
DIGITAL
8.
Play back your CD player.
9.
When you press the [INPUT SOURCE] pad so it’s lighted, the external input sound will be heard.
When you press the [INPUT SOURCE] pad once again and switch off its illumination, the sound will stop.
10.
Use the AUDIO IN REC LEVEL knob to adjust the volume.
Adjust the AUDIO IN REC LEVEL knob until the level is as high as you can get it without causing the knob’s
level indicator to light.
level indicator to light.
If you made connections to DIGITAL IN in step 3, the AUDIO IN REC LEVEL knob has no effect.
The SP-606 lets you sample up to approximately eleven minutes of sound (monaural).
Copyright law prohibits you from recording (sampling) copyrighted audio material belonging to a
third party without permission for any purpose other than personal enjoyment. Do not use this
device to make illegal recordings.
third party without permission for any purpose other than personal enjoyment. Do not use this
device to make illegal recordings.
Roland Corporation accepts no responsibility for any damages or penalties you may be required to
pay as a result of making illegal recordings using Roland-manufactured equipment.
pay as a result of making illegal recordings using Roland-manufactured equipment.
As an example, here’s how to sample sound from a CD player.
Connect your CD player to the SP-606
1.
Make sure that the SP-606 and your CD player are powered off.
2.
On the top panel, turn the AUDIO IN REC LEVEL knob to the minimum (far left).
3.
To prevent malfunction and/or damage to speakers or other devices, always turn down the volume,
and turn off the power on all devices before making any connections.
and turn off the power on all devices before making any connections.
4.
Power up your CD player.
5.
Specify the input jack, and adjust the input level
6.
Hold down [FUNC] and press [INPUT SOURCE] to get the INPUT
SETTING screen.
SETTING screen.
7.
Turn the VALUE dial or use [DEC][INC] to set “Input Select” as
follows.
follows.
If you made connections to
INPUT L/R
in step 3:
LINE
If you made connections to
DIGITAL IN
in step 3:
DIGITAL
Recording Your Own Samples
Preparations for Sampling
SP-606_e.book 26 ページ ２００４年６月２１日 月曜日 午前１０時８分