Roland SP-606 用户手册
87
Troubleshooting
This section provides points to check and actions to take when
the SP-606 does not function as you expect. Refer to the
appropriate section for the problem you are experiencing.
the SP-606 does not function as you expect. Refer to the
appropriate section for the problem you are experiencing.
If you find the screen display difficult or impossible to read,
hold down [
hold down [
KNOB ASSIGN
] and turn the
VALUE
dial to
adjust the contrast.
No Sound/Insufficient Volume
Is the SP-606 correctly connected to your external
equipment?
equipment?
Could your audio cables be broken?
Could you be using a cable with a built-in resistor?
Use connection cables that do not have built-in resistors (such
as the Roland PCS series).
as the Roland PCS series).
Could the volume be lowered on the connected amp
or mixer?
or mixer?
Adjust the volume to an appropriate level.
Could the volume of the SP-606 be too low?
Adjust the volume to an appropriate level.
Is there sound from the headphones?
If you hear sound from the headphones, the problem lies in a
broken cable or in the amp or mixer that is connected. Check
the connections and the connected devices. (p. 20)
broken cable or in the amp or mixer that is connected. Check
the connections and the connected devices. (p. 20)
In the MASTER screen, could “In Level,” “Low Gain,”
or “High Gain” be lowered?
or “High Gain” be lowered?
Adjust the various levels in the
MASTERING
screen
Is the SP-606 in External mode?
Specific Pads Do Not Sound
Could the level of the sample be lowered?
Try turning off the MFX1 and MFX2 switches.
If you now hear sound, it may be that the level was being
constrained by the MFX parameters, or that the MFX type was
set to “
constrained by the MFX parameters, or that the MFX type was
set to “
ENVELOPER (PAD)
.” Adjust the parameters to
appropriate settings. If the MFX type is “
ENVELOPER
(PAD)
,” striking a pad will apply an envelope so that the
sound will be heard.
The Sound Stops Unexpectedly
Could a Mute Group be specified?
Could “Trig Mode” be set to ALTERNATE?
If “Trig Mode” is set to
ALTERNATE
, the sample will
alternately play or stop each time you strike the pad. If you
want the sample to sound each time you strike the pad, set
“Trig Mode” to
want the sample to sound each time you strike the pad, set
“Trig Mode” to
GATE
or
SHOT
The Sound Does Not Stop
Could “Trig Mode” be set to SHOT?
If “Trig Mode” is set to
SHOT
, the sample will play all the way
to its end, so that for a long sample it may seem that the sound
does not stop. If you set “Trig Mode” to
does not stop. If you set “Trig Mode” to
ALTERNATE
, the
sample will alternately play or stop each time you strike the
pad. Or, if you set “Trig Mode” to
pad. Or, if you set “Trig Mode” to
GATE
, the sample will
Could the Loop setting of the sample be turned on?
Can’t Control the Volume by Varying
Your Striking Force on the Pads
Your Striking Force on the Pads
Could “Pad Velocity” be set to a fixed setting?
If you want to control the volume by varying your striking
force on the pads, you must set “Pad Velocity” to
force on the pads, you must set “Pad Velocity” to
REAL
The Screen Display Is Not
Visible, or Is Difficult to Read
Visible, or Is Difficult to Read
Problems When Playing
Sounds
Sounds
SP-606_e.book 87 ページ ２００４年６月２１日 月曜日 午前１０時８分