Roland VS-1824 用户手册
194
Chapter 13 CD-RW and Mastering
Canceling the capture
If you want to cancel capture in the middle, operate as follows.
1. Press [EXIT/NO]
A message “Abort?” appears.
2. Press [ENTER/YES] to cease capture.
Press [EXIT/NO] to re-start capture.
Capturing Time
Capturing time differs according to recording mode as
follows.
follows.
Recording Mode
CDR (CD writing) .... Approx 40% of actual time
MAS (Mastering) ...... Approx 80% of actual time
Others......................... Approx 150% of actual time
Connecting an external
CD-R/CD-RW Drive
CD-R/CD-RW Drive
* To prevent malfunction and or damage to speakers or other
devices, always turn down the volume and turn off the power
on all devices before making any connections.
on all devices before making any connections.
1. Make sure both the VS-1824 and the CD-R/CD-RW drive
are off. Connect the CD-R/CD-RW drive to the VS-1824
as shown below. If the CD-R is the only SCSI device
connected to the VS-1824, or if it is the last device in the
chain, make sure that the terminator plug is connected to
the remaining SCSI port on the CD-R.
as shown below. If the CD-R is the only SCSI device
connected to the VS-1824, or if it is the last device in the
chain, make sure that the terminator plug is connected to
the remaining SCSI port on the CD-R.
2. Turn on the power of the CD-R/CD-RW drive.
fig.07-01
3. Turn on the power of the VS-1824.
* In order for the VS-1824 to properly recognize the CD-R/CD-
RW drive upon boot-up, it is very important to turn the CD-
R/CD-RW drive on first, and then turn on the VS-1824.
R/CD-RW drive on first, and then turn on the VS-1824.
4. Turn on the power of connected audio equipment.
5. Raise the volume of the audio devices as desired.
0
0