Roland VS-1824 用户手册
239
Chapter 19 Using a DAT Recorder (DAT Backup)
Chapter 19
Saving Song Data to DAT
(DAT Backup)
(DAT Backup)
Use the following procedure to back up song data on the
current drive.
current drive.
1. Connect the VS-1824 and the DAT recorder as shown
below.
fig.09-02a
fig.09-02b
2. Set the DAT recorder so it is able to record digital signals.
* Normally the sample rate at which song data is transmitted is
set to 48kHz. This sample rate has no relation to the sample
rate of the song data. If your DAT recorder requires you to set
the sample rate, set it to 48 kHz.
rate of the song data. If your DAT recorder requires you to set
the sample rate, set it to 48 kHz.
3. Hold [SHIFT] and press [F6 (UTILITY)].
The Utility Menu icon appears in the display.
4. Press [PAGE] so “DATBk” appears in the display above
[F6]. Press [F6 (DATBk)].
“DAT Backup Ready?” appears in the display.
5. Press [ENTER/YES] and “Store Current?” will be
displayed.
If you wish to save changes made to the current song,
press [ENTER/YES]; if not, press [EXIT/NO]
press [ENTER/YES]; if not, press [EXIT/NO]
fig.09-03
6. Press [
], [
], [
], and [
] to move the
cursor to “Source Song.”
7. Use the TIME/VALUE dial to move the cursor to the
song you want to copy and press [F3 (MARK)].
By pressing [F2 (ALL)], you can place and remove marks
from all songs.
from all songs.
Press [F1 (SelSg)] to view a directory of songs. After
marking songs, press [F1 (Back)].
marking songs, press [F1 (Back)].
fig.09-03a
DAT recorder
Digtal In
Optical
DAT recorder
Digital In
Coaxial