Roland VS-1824 用户手册
31
Chapter 1 Before You Start (VS-1824 Terminology)
Chapter 1
Effects Section
About the Effect Expansion Board
One VS8F-2 effect expansion board is pre-installed in the
VS-1824. Up to two of these effect expansion boards can be
installed in the VS-1824. With and additional VS8F-2 effect
installed in the VS-1824, up to four high-quality stereo effects
will be available for your use.
VS-1824. Up to two of these effect expansion boards can be
installed in the VS-1824. With and additional VS8F-2 effect
installed in the VS-1824, up to four high-quality stereo effects
will be available for your use.
With just a single VS8F-2 installed, you will be able to use
EFFECT A (FX1/2). With two VS8F-2s installed, you will be
able to use both EFFECT A (FX1/2) and EFFECT B (FX3/4).
EFFECT A (FX1/2). With two VS8F-2s installed, you will be
able to use both EFFECT A (FX1/2) and EFFECT B (FX3/4).
fig.01-19
* To install a VS8F-2, please refer to “Installing the Effect
Expansion Board” (User Guide p. 6, 9).
Connecting Effects
On the VS-1824, there are two ways to connect the effects
devices. Please read and understand these differences
described below.
devices. Please read and understand these differences
described below.
Insert:
The channel’s signal is re-directed into and out of the effect
between the channel’s equalizer and fader, or before the
Master fader. Connect an effect in this manner if you want it
to change the characteristics of the sound itself, such as when
between the channel’s equalizer and fader, or before the
Master fader. Connect an effect in this manner if you want it
to change the characteristics of the sound itself, such as when
using distortion or overdrive effects or dynamics processing
such as compression or vocal multi-effects.
such as compression or vocal multi-effects.
When inserting an effect into one of the channels or into the
Master Block, the effect cannot be used in another channel.
For example, if you insert FX1 into Channel 1, then no other
channel can access FX1.
Master Block, the effect cannot be used in another channel.
For example, if you insert FX1 into Channel 1, then no other
channel can access FX1.
fig.01-20
Loop:
Besides the RECORDING bus and the MIX bus, the output of
each channel can also be sent to the EFFECT bus. Use this
routing with effects such as reverb and delay, when you
want to mix the original un-effected, or “dry,” sound with
the sound after effects have been applied.
each channel can also be sent to the EFFECT bus. Use this
routing with effects such as reverb and delay, when you
want to mix the original un-effected, or “dry,” sound with
the sound after effects have been applied.
fig.01-21
* The VS8F-1 effect expansion board is for use with the VS-880.
It cannot be used in the VS-1824.
EQ
Fader
Pan
FX1
MIX bus or REC bus
EQ
Fader
Pan
FX1
FX Pan
MIX bus or REC bus
FX bus