Roland SPD-S 用户手册
45
Chapter 2 Wave Editing
Chapter 2
Wave Edit Parameters
WAVE SETUP
Define the attributes of a wave.
Set the following parameters. Press the PAGE buttons to change parameters and press [-]/[+] to change the value.
When you change the value of Type, the following parameters are also set automatically. (They can be individually changed
afterwards.)
afterwards.)
Priority of sound elimination when there are insufficient voices (lack of polyphony) available:
When more than eight voices are requested, SINGLE waves drop out earlier than PHRASE waves.
When more than eight voices are requested, SINGLE waves drop out earlier than PHRASE waves.
In general, percussion sounds should be set to SINGLE. However, with longer sounds, such as cymbals, which may get cut off
while they are still sounding, please try the following settings so the disruption in the sound is not as obvious: Type = PHRASE,
Assign = POLY, Loop = OFF, and Trigger = SHOT.
while they are still sounding, please try the following settings so the disruption in the sound is not as obvious: Type = PHRASE,
Assign = POLY, Loop = OFF, and Trigger = SHOT.
Parameter
Value
Descriptions
Type
SINGLE,
PHRASE
PHRASE
Specify the wave type.
SINGLE: For single sounds, mainly short percussion sounds.
PHRASE: Produced as a phrase-for loops. The wave tempo can be synchronized with effects. (See
PHRASE: Produced as a phrase-for loops. The wave tempo can be synchronized with effects. (See
Patch mode.)
* When you change the Type value during sound production, the sound is stopped.
Parameter
SINGLE
PHRASE
Assign
POLY
MONO
Loop
OFF
ON
Reverse
OFF
OFF
Trigger
SHOT
ALTERNATE
If you hold down [SHIFT] and press [FUNC], the parameter is reset to its initial value.
SPDS_e.book 45 ページ ２００４年４月１９日 月曜日 午前９時５８分