Roland AT 5 用户手册

Before You Start Playing

Setting Up the Music Stand

fig.01-03

1. Attach the music stand by inserting it into the

two holes.

Connecting the AC Adaptor

1. First, make sure that the [Power On] switch at

the panel’s left side is OFF (not pushed in).

2. Connect the supplied AC adaptor and power

cord.

3. Connect the AC adaptor to the DC In jack on the

rear panel.

4. Loop the AC adaptor cord around the cord hook

to fasten it in place.

* To prevent the inadvertent disruption of power to your unit

(should the plug be pulled out accidentally), to avoid applying

undue stress to the DC In connector, anchor the power cord

using the cord hook, as shown in the diagram. Even if the cord is

fastened, strong tension applied to the cord may cause it to be

damaged or broken. Be careful not to pull the cord accidentally,

or to apply strong pressure to it.

5. Plug the power cord into a power outlet.

fig.01-05

* Only use the power cord and AC adaptor supplied with this

instrument.

* Whenever you do not intend to use the instrument for extended

periods of time, pull out the power cord from the AC outlet.