Roland HP107 用户手册

Before You Start Playing

Connecting the Pedal Cord

Insert the pedal cord into the Pedal connector on the

rear panel of the HP107.

fig.00-01

Connecting the Speaker

Cable

As shown in the diagram, connect the speaker cable

leading from the speaker box of the stand to the

speaker connector located on the rear bottom of the

HP107.

Push the speaker cable in until it clicks into position.

NOTE

Do not put anything that contains water (e.g., flower vases) on

this unit. Also, avoid the use of insecticides, perfumes, alcohol,

nail polish, spray cans, etc., near the unit.

The speakers of this piano are mounted beneath the upper

surface, and face upwards. Malfunctions or accidents may occur

if liquids contact any part of the speakers.

Connect the Power Cord

Insert the included power cord into the AC inlet on the

bottom panel of the HP107.

Plug the power cord into a power outlet.

NOTE

Use only the attached power-supply cord.

fig.00-02

Setting Up the Music Rest

Grasping the music rest with both hands, lift it toward

you until its in the upright position.

Use the support on the back of the music rest to keep

the stand in place.

The angle of the music rest can be set to any of three
positions.

fig.mu_stand

■

Folding down the music rest

Raise the support located on the back of the music rest,

then gently fold down the music rest.

■

Using the music holders

You can use the holders to hold pages in place.
When not using the holders, leave them folded down.

fig.mu_stand4

Speaker cable

Speaker connector

Clip portion

Speakers

HP107_e.book 12 ページ２００５年７月２５日　月曜日　午後４時５０分