Roland HPi-7S 用户手册

下载
页码 136
 
75
 
Recording Your Performance
 
1.
 
Use the [
 (Bwd)] or [
 (Fwd)] button to move to the measure that you 
want to re-record.
 
2.
 
Press the [
 (Rec)] button.
 
A screen like the one shown below appears.
 
fig.Rec-OverRec1-e
 
3.
 
Press the cursor left or right button to select <Add On>, then press the [
button
 
This sets the HPi-7S so you can record while listening to the song already recorded.
 
fig.d-Rec-OverRec2-e_50
 
4.
 
Press the track button for the track that you want to re-record.
 
The indicators of the button you pressed and of the [
 (Play/Stop)] button will 
blink, and the HPi-7S enters recording-standby mode.
 
5.
 
Press the [
 (Play/Stop)] button to start recording.
 
The count is played, and then recording begins.
When recording begins, the [
 (Play/Stop)] button and [
 (Rec)] button 
indicators will light.
Go ahead and perform on the keyboard.
 
6.
 
Press the [
 (Play/Stop)] button to stop recording.
 
The [
 (Play/Stop)] button and the [
 (Rec)] button indicators will go out.
 
Re-recording
 
When you want to re-record, specify the track button whose performance you want to re-record, then record again.
When you select a previously recorded track button and re-record, the performance from the location at which you 
begin recording up to the location at which you stop recording will be replaced by the newly re-recorded 
performance.
 
fig.panel-Rec-ReRec-e
When you want to record over 
again after deleting all of the 
previous recording, refer to 
“Erasing a Recorded Song” (p. 
76).
When deleting the performance 
for a specific track button, refer 
to “Erasing the Performance on 
Specific Tracks” (p. 76).
The selected setting turns 
orange.
NOTE
The song tempo is stored within 
the song you selected. 
HPi-7S-e.book 75 ページ 2007年8月27日 月曜日 午後2時39分