Roland HPi-7 业主指南

 

Insert the pedal cable into the Pedal connector on the rear panel of the 

HPi-7.

 

Push the speaker cable in until it clicks into position.

 

*

Do not put anything that contains water (e.g., flower vases) on this 

unit. Also, avoid the use of insecticides, perfumes, alcohol, nail 

polish, spray cans, etc., near the unit. 

The speakers of this piano are mounted beneath the upper 

surface, and face upwards. Malfunctions or accidents may occur if 

liquids contact any part of the speakers.

 

The music rest of the HPi-7 contains a liquid crystal display screen.

Use the following procedure, and handle the music rest with care.

 

fig.mrest

 

*

The power must be off when connecting the cable of the music 

rest.

 

fig.LCDcord-e

 

Insert the included power cord into the AC inlet on the bottom panel 

of the HPi-7, and then plug it into an AC power outlet.

 

*

Use only the included power cord.

 

fig.ACcord-e

 

When you connect headphones, no sound will be output from the 
internal speakers.
The headphone volume is adjusted by the [Volume] knob (p. 12) 
of the HPi-7.

 

*

Please use stereo headphones.

*

Make sure to use only Roland headphones. Headphones from 

other manufacturers may be unable to provide sufficient volume.

 

fig.headphones

 

• To avoid damaging or severing the headphone cord, be 

sure to handle the headphones by holding the phones 
themselves, and grasping the plug and not the cord when 
pulling the headphone plug.

• To prevent possible auditory damage, loss of hearing, or 

damage to the headphones, the headphones should not be 
used at an excessively high volume. Listen at appropriate 
levels.

• The headphones may be damaged if the volume is too 

high when they are plugged in. Connect the headphones 
only after turning the volume down completely.

Speaker cable

Speaker connector

Clip portion

Speakers

Bottom rear of the HPi-7

HPi-7_e.book 9 ページ ２００５年１月１８日　火曜日　午後４時３９分