Crate Amplifiers V18-212 用户手册

V18-112/V18-212 Tube Guitar Amplifier with Reverb

11. AC LINE CORD: The grounded power 

cord should only be plugged into a 
grounded power outlet that meets 
all applicable electrical codes, and is 
compatible with the voltage, power, and 
frequency requirements stated on the 
V50-112 rear panel. Do not attempt to 
defeat the safety ground connection.

12.  Voltage Select Switch: Set this switch 

to “115” for 120 VAC mains, and to 
“230” for 220-240 VAC mains.

 

With the amplifier power cord 
unplugged, use the tip of a small flat-
blade screwdriver to slide this switch to 
the proper position.

13. REVERB IN Jack: The V18 is shipped 

with a cable connected from this jack to 
the input of the internal spring reverb.

14. REVERB OUT Jack: The V18 is 

shipped with a cable connected from 
this jack to the output of the internal 
spring reverb.

15. LINE OUT: Use this 1/4" TS jack to 

send the signal from the preamplifier 
stage of the V18 to a mixer or recorder. 
The signal comes after the EQ stage 
but before the reverb stage.

16. SPEAKER 8 OHMS: The V18 is 

shipped with a cable connected from 
this jack to the internal speaker(s).

 

V18-112: One 8-ohm speaker
V18-212: Two 16-ohm speakers in 
              parallel = 8 ohm load

 

SERIAL NUMBER

MANUFACTURING DATE

This device complies with part 15 of the FCC Rules.  Operation 
is subject to the following two conditions: 
(1) This device may not cause harmful interference, and 
(2) This device must accept any interference received, including 
interference that may cause undesired operation.

~120-240VAC

50-60 Hz 

N222

AVIS: RISQUE DE CHOC ELECTRIQUE — NE PAS OUVRIR

WARNING: 

TO REDUCE THE RISK OF FIRE OR ELECTRIC SHOCK, DO NOT 

EXPOSE THIS EQUIPMENT TO RAIN OR MOISTURE.  DO NOT REMOVE COVER. NO 
USER SERVICEABLE PARTS INSIDE. REFER SERVICING TO QUALIFIED PERSONNEL.

115