Roland JUPITER-80 用户手册

Editing a Live Set

You can edit a Live Set by switching the Tones in the Live Set, and 

by adjusting offset values relative to the value of each tone.

The Live Set screen (p. 32) shows basic information about the 

currently selected Live Set.

Tone name

Level of each 

layer.

View the Live Set 

Common screen.

View the Live Set 

Effects screen.

View the Live Set Effects 

Routing screen.

View the Live 

Registration 

screen.

Switch between the Upper 

Part and Lower Part

The following parameters are stored in a Live Set.

Settings common to the entire Live Set

•  Live set name, Live Set category
•  Volume
•  Filter
•  Phase lock, etc.

Settings for each layer

•  Layer on/off
•  Volume
•  Pan
•  Layer audio output destination and send level
•  Keyboard range, etc.

MFX settings

•  Layer audio output destination and send level
•  Send level to MFX
•  MFX on/off
•  MFX type selection
•  MFX volume
•  MFX settings, reverb settings
•  Send levels from the Tone to reverb, and from MFX to 

reverb, etc.

Offset settings for each layer

For a SuperNATURAL 

Synth Tone

For a SuperNATURAL 

Acoustic Tone

•  Pitch
•  Filter
•  Amp
•  LFO
•  Modulation
•  Portamento, etc.

•  Noise level
•  Variation, etc.

A Registration consists of up to four Parts. Editing will be 

easier if you’re listening only to the Parts that are selected for 

the Live Set you want to edit (p. 37).

When you edit the parameters of a Live Set, you are specifying 

a relative increase or decrease applied to the value of the Tone; 

the actual tone itself is not affected.
This means that even if the same tone is used by another Live 

Set, you’ll be able to edit without affecting the other Live Set.

To edit a Live Set, you’ll start from the Live Set screen.

In the Live Set screen (p . 32), touch the button 

Tabs

In this example, the Upper Part’s Live Set is edited.