Roland LX-10 用户手册
18
Before You Play
Before connecting cables to the bottom panel (the
back edge of the LX-10’s bottom), you’ll need to
remove the rear board upper.
back edge of the LX-10’s bottom), you’ll need to
remove the rear board upper.
To remove the rear board upper, remove the three
screws from the locations shown in the illustration.
screws from the locations shown in the illustration.
Plug the speaker cable extending from the stand
into the SPEAKER connector located at the rear of
the LX-10’s bottom panel.
into the SPEAKER connector located at the rear of
the LX-10’s bottom panel.
Pay attention to the shape of the speaker cable’s
connector, and insert it until you hear it click
securely into place.
connector, and insert it until you hear it click
securely into place.
fig.SpeakerCable.eps
Plug the pedal cord extending from the stand into
the Pedal connector located at the rear of the LX-
10’s bottom panel.
the Pedal connector located at the rear of the LX-
10’s bottom panel.
fig.PedalCord.eps
1.
Make sure that the [Power] switch located at
the left side of the front panel is off (in the
upward position).
fig.PowerOff-e.eps
2.
Turn the [Volume] knob all the way toward
the left to minimize the volume.
3.
Connect the included power cord to the AC In
(AC Inlet) located at the rear of the bottom
panel.
4.
Plug the other end of the power cord into an
AC outlet.
fig.PowerCord.eps
You must use the power cord included with the LX-10.
Getting Ready to Play
Connecting the Speaker Cable
Connecting the Pedal Cord
Rear Board Upper
Connecting the Power Cord
OFF
Upward
position
3
4
NOTE
LX-10_e.book 18 ページ ２００８年９月２２日 月曜日 午前１０時５１分