Roland XV-88 用户手册

fig.00-02

You can apply a variety of effects to sounds simply by 
moving your hand. 

→

Switches the D Beam controller on/off.

Adjusts the overall volume that is output from the rear panel 
OUTPUT jacks and PHONES jack. 

→

 (Quick Start; p. 18)

Use the four sliders to modify sounds in realtime.

Press this button ON when modifying filter and/or envelope 
settings in realtime using the four sliders (CUTOFF/
RESONANCE/ATTACK/RELEASE). 

→

Press this button ON when adjusting volume balance in 
realtime using the four sliders (1/2/3/4). 

→

Can be switched on when you wish to assign various 
parameters to the four sliders, and modify the sound as you 
play (C1/C2/C3/C4). 

→

 (Quick Start; p. 66)

The buttons in this section allow you to assign various 
functions to the keys of the XV-88’s keyboard.

Switches Portamento on/off. 

→

Specifies playing a single note at a time. 

→

Specifies transposing the keyboard in semitone steps. 

→

Switches Arpeggiator on/off. 

→

These buttons adjust the pitch of the keyboard in octave 
steps. 

→

Pressing either of these buttons while holding down 
[TRANSPOSE] allows you to set the desired amount of 
transposition. 

→

The buttons in this section select modes. The button indicator 
of the selected mode will light/blink. 

→

Pressed to get into Performance mode. Hold down [SHIFT] 
while you press [PERFORM] to select GM mode. 

→

Pressed to get into Patch mode. By holding down 
[PERFORM] and pressing [PATCH], you can modify the 
settings of the Patch and Rhythm Set that is assigned to each 
part of the performance. 

→