Roland XV-88 用户手册

For details regarding effect settings, refer to the pages 
shown below.

•

•

•

•

These parameters determine how each Part will transmit and 
receive MIDI messages.

fig.03-09

Sets the MIDI receive channel for each Part.

If this is set to the same channel as the Control Channel 
parameter (SYSTEM/MIDI/PERFORM MIDI), 
attempting to use MIDI messages (Program Change and 
Bank Select) from an external device to select Patches 
will select Performances instead. If you want to select 
Patches, change the Control Channel parameter to a 
different setting (p. 169).

Specifies whether each Part will receive MIDI messages 
(ON), or not (OFF) from external MIDI devices.

When set to OFF, the Part will respond to the keyboard, but 
not to the external MIDI devices. Normally, you should leave 
this ON, but you can turn it OFF when you do not want a 
specific Part to be playing during song playback.

You can also set the Rx Sw parameter on the PERFORM 
PLAY page. Hold down [SHIFT] and press ZONE/
PART SELECT [1/9]–[8/16]; Rx Sw is on when the 
indicator is lit, and off when the indicator is 
extinguished. When the [1-8/9-16] indicator is 
extinguished, Parts 1–8 are switched on and off, and 
when the [1-8/9-16] indicator is lit, Parts 9–16 are 
switched on and off (p. 38).

Mute Sw temporarily mutes (MUTE) or releases the mute 
(OFF) for the performance of each Part.

Use this setting when, for example, you want to use the 
instrument for karaoke by muting the Part playing the 
melody, or when you want to play something using a 
separate sound module.

The Mute Sw parameter does not turn the Part off, but 
rather mutes the sound by setting the volume to 0. 
Therefore, MIDI messages are still received.

fig.03-10

fig.03-11

RxSWITCH determines whether MIDI messages for the 
following parameters in each MIDI channel are received 
(ON), or not received (OFF).