Roland AX-Synth 用户手册
Using the AX-Synth as MIDI controller
30
The AX-Synth’s FAVORITE
[WRITE] button flashes to
indicate that SysEx data are being received. When all
data blocks have been received, the display changes
to “Urt” (writing data) and the FAVORITE
data blocks have been received, the display changes
to “Urt” (writing data) and the FAVORITE
[WRITE]
button lights.
(5) Wait until “dne” appears in the AX-Synth’s display
and until the FAVORITE
[WRITE] button starts flash-
ing.
Note: If the “Err” message appears during the reception of
bulk data, the AX-Synth was unable to process the data
correctly, then stop the sequencer. The FAVORITE
bulk data, the AX-Synth was unable to process the data
correctly, then stop the sequencer. The FAVORITE
[WRITE]
button will go dark at that time. In such a case, please
repeat the entire procedure.
repeat the entire procedure.
(6) Switch the AX-Synth off, wait a moment, then
switch it back on again.
Note: We recommend using the librarian software
included in the “AX-Synth Editor” to transmit and receive
the AX-Synth’s settings to your computer. This software is
available for the Mac and PC platforms and can be down-
loaded from Roland’s website: www.Roland.com.
included in the “AX-Synth Editor” to transmit and receive
the AX-Synth’s settings to your computer. This software is
available for the Mac and PC platforms and can be down-
loaded from Roland’s website: www.Roland.com.
AX-Synth_e2 Page 30 Monday, October 12, 2009 3:41 PM