Roland AX-Synth 用户手册

Additional functions

If you are not sure whether your AX-Synth contains 
fresh (or fully recharged) batteries, you may want to 
check how much power is left before going on stage.

(1) Hold down the 

[SHIFT] button and press the [V-LINK] 

button.

The display now shows the remaining battery charge 
as a percentage value (between “0” and “100”).

(2) Release the 

[SHIFT] to leave this function.

Note: The battery charge indication is only an approxima-
tion.

Note: Do not use this function while the AC adaptor is 
connected, because the displayed value will always be 
“100”.

When the AX-Synth runs on batteries, it is programmed 
to go into sleep mode after a while. By default, this 
interval is set to “15” (minutes). But you can change it 
as follows:

(1) Hold down the 

[SHIFT] button and press the PGM 

CHANGE 

[DEC] button.

The display shows the current setting and the 

[WRITE] 

button flashes.

(2) Keep holding the 

[SHIFT] button and press the PGM 

CHANGE 

[DEC] button to select the desired sleep 

mode interval.
The possibilities are: “Off” (the sleep function is off), 
“15”, “30” and “60” (minutes).

(3) Press the 

[WRITE] button to confirm your selection.

(4) Release the 

[SHIFT] button.

The AX-Synth allows you to change and store certain 
settings, thereby overwriting its original settings.

Furthermore, in-depth editing using the “AX-Synth Edi-
tor” software may cause one AX-Synth to sound and 
behave radically different from another,. This may 
become a problem when you are using someone else’s 
AX-Synth. 

This function returns all of the AX-Synth’s parameters to 
their factory settings. 

Note: Consider archiving your settings using the Bulk Dump 
function (see p. 29) before loading the factory defaults.

Here is how to load the factory settings.

(1) Hold down the VARIATION 

[INC÷+] + [DEC÷–] + TONE 

[7] (ORGAN/CLAVI) buttons and switch on the 
AX-Synth.
The display shows the “FCt” message and the 

[WRITE] 

button flashes.

(2) Press the 

[WRITE] button to load the factory set-

tings.
All indicators flash.

(3) Wait until the “dne” message appears in the dis-

play, then switch the AX-Synth off, wait a few sec-
onds, and switch it back on.

Note: Never switch off the AX-Synth while the [WRITE] 
button is still lit, because doing so may damage it.

In some cases, your Roland dealer or local Roland dis-
tributor may ask you which firmware version you are 
using when you report a problem. In other cases, you 
may need want to check whether the AX-Synth you are 
using contains the latest firmware version. In such cases, 
proceed as follows:

(1) Hold down the VARIATION 

[INC÷+] + [DEC÷–] + TONE 

[8] (CHOIR/PIANO) buttons and switch on the 
AX-Synth.
The display shows the version number of the firm-
ware your AX-Synth is using.

(2) Switch the AX-Synth off, wait a few seconds, then 

switch it back on again.

AX-Synth_e2  Page 34  Monday, October 12, 2009  3:41 PM