Roland 5 用户手册

下载
页码 82
Arpeggiator
Arpeggiator
Arpeggiator
Arpeggiator    
                          
                          
                          
                          Europa User Guide
Europa User Guide
Europa User Guide
Europa User Guide 
Page 40 
Chord mode (8)
Chord mode (8)
Chord mode (8)
Chord mode (8)    
Chord mode causes 4 notes to be played simultaneously, or 8 notes to be played if link mode is enabled. 
The recorded sequence is divided in to groupings of 4 notes (or 8 notes if in link mode) and all notes are 
played simultaneously. A maximum of 4 chords can be recorded, either four 4 note chords, or four 8 note 
chords (if in link mode). If a non-multiple of 4 or 8 notes is recorded, the remaining notes are considered a 
short chord and are played.  
 
If the following 16 note sequence is recorded into Europa: 
 
C E G A# D F A C# E G# B E F A C E 
 
Assuming chord mode enabled, link mode is disabled, and C is held, each step of the arpeggiator would 
play (each line assumes notes are played simultaneously): 
 
C E G A# 
D F A C# 
E G# B E 
F A C E 
…repeat…. 
 
If E, F, and G are held down, the above 4 chords play in the key of E, F, G, and repeat.  
 
If only 14 notes of the above listed note sequence were recorded (missing the C and E off the last chord), 
then the 4
th
 chord would just play the “short chord” of F & A. 
 
When link mode is enabled, the behavior as described above is the same with the exception of the 
sequence being a maximum of 32 notes and eight note chords are played instead of four note chords. 
Also, link mode joins the upper and lower rhythms and sequences, so if the Jupiter 6 is in either SPLIT
SPLIT
SPLIT
SPLIT
 
mode and chord mode is enabled, both SPLITS
SPLITS
SPLITS
SPLITS
 follow a 32 step rhythm and four note chords. 
 
Programming the arpeggiator step rhythm
Programming the arpeggiator step rhythm
Programming the arpeggiator step rhythm
Programming the arpeggiator step rhythm    
The arpeggiator has two 16 step rhythms (upper/lower rhythms) or one 32 step rhythm when 
rhythm/sequence link mode is enabled. It is always active when any arpeggiator mode has been selected. 
Enable the rhythm programming mode by pressing UP
UP
UP
UP
 and waiting for 1 second. The PATCH 
PATCH 
PATCH 
PATCH 
PRESET
PRESET
PRESET
PRESET
, A
A
A
A----F
F
F
F
, 1
1
1
1----8
8
8
8
, and MANUAL
MANUAL
MANUAL
MANUAL
 buttons become beats 1 through 16 as shown in Figure 11: 
 
A
B
C
D
E
F
1
2
3
4
5
6
7
8
Manual
Patch
preset
Arpeggiator step rhythm - beat 1 (patch preset) through beat 16 (manual) - On=Step, Off=No step
 
Figure 11 - Arpeggiator step rhythm programming buttons 
 
While the arpeggiator is running, a winking LED indicates the current beat. This is very similar to the 
operation of the Roland TR-707, TR-808, and TR-909 drum machines. Pressing one of the buttons shown 
in Figure 11 will toggle the step on or off. A lit LED indicates the arpeggiator will step to the next note(s) 
when that beat is reached, while an unlit LED indicates the arpeggiator will not step on that beat.