Roland A-PRO 用户手册

Using A-PRO Editor

Here you can specify the value of various parameters for the MIDI message you 
selected in the Assign Message selection list 

.

For details on the parameters of each MIDI message, refer to  “Message Parameters” (p. 
33)

This specifies the USB port from which the MIDI messages will be transmitted to a USB-
connected computer.

If the controller is a button, this specifies the button mode.

If the controller you’re editing is [A1]–[A8], you can specify the aftertouch setting.

You can enter a name to describe the function you’ve assigned to the controller; this 
name is shown in the A-PRO’s display. Up to sixteen single-byte alphanumeric 
characters can be entered. The name you enter here is shown in the “PARAMETER” field 
of the HTML file exported by the [File] menu command [Export Assign List].

If the controller you’re editing is [R1]–[R9] or [S1]–[S9], you can make virtual center click 
settings (p. 55).
This broadens the range in which the center value is transmitted.

Port 1

MIDI messages will be transmitted to “A-PRO 1.”

Port 2

MIDI messages will be transmitted to “A-PRO 2.”

Port 1+2

MIDI messages will be transmitted to both “A-PRO 1” and “A-PRO 2.”

Unlatch

Turns on when you press the button; turns off when you release it.

Latch

Alternately turns on/off each time you press the button.

Increase

Each time you press the button, the value will be incremented by one 
(or decremented by one if the maximum value is below the minimum 
value). When the value reaches the maximum value (minimum value), 
it will jump back to the minimum value (maximum value).
* This cannot be selected if the message type is Note.

OFF

No aftertouch

Channel Pressure

Transmitted as channel pressure messages

Polyphonic Key Pressure

Transmitted as polyphonic key pressure messages.

OFF

No insensitive range in the center

ON

Insensitive range in the center

A-300_500_800C_e.book  25 ページ  ２０１０年２月２２日　月曜日　午後９時１３分