Roland RD-300GX 用户手册

 

Detailed Settings for Each Function ([EDIT] Button)

 

You can switch the RD-300GX’s Setups with MIDI messages 
from an external MIDI device.

Set the MIDI Receive channel for receiving the MIDI messages 
(Program Changes) from the external MIDI device to be used 
for switching Setups.

When not switching Setups from an external MIDI device, set 
this to OFF.

When the SETUP Control Channel settings are 
transmitted along with the part’s MIDI receive 
channel, switching of Setups takes priority over the 
switching of Tones.
For more information about switching Setups, refer 
to “Switching Setups” (p. 80).

If you intend to connect to a computer using the USB 
connector, you need to make the following setting before you 
make the connection. 

After changing this setting, turn the power off and then on 
again.

Select the “ORIGINAL” setting if transmission and 
reception of MIDI data using the standard USB 
driver included with your computer is too slow.

In some cases, when USB memory is connected to the USB 
MEMORY connector, it may take longer for data to be loaded, 
or data may fail to be loaded successfully. If this occurs, you 
may be able to solve the problem by changing the USB 
memory setting.

After changing this setting, turn the power off and then on 
again.

Switch the polarity of pedals connected to the RD-300GX.

This can be set individually for each of the Pedal jacks on the 
rear panel (DAMPER, CONTROL).

On some pedals, the electrical signal output by the pedal 
when it is pressed or released is the opposite of other pedals. 
If your pedal has an effect opposite of what you expect, set 
this parameter to REVERSE.

If you are using a Roland pedal (that has no polarity switch), 
set this parameter to STANDARD.

This specifies how the indicators will appear when off.

 

1–16, OFF

 

ORIGINAL

Select this if you’re using the 
USB driver on the included CD-
ROM (Audio Key Utility 2), or a 
USB driver you downloaded 
from the Roland website.

GENERIC

Choose this if you want to use 
the standard USB driver that 
was included with your 
computer.

 

MODE1, MODE2

 

STANDARD, REVERSE

 

NORMAL

The indicator will be lit if a 
function is on, and will be 
extinguished if it is off.

DIMLY

The indicator will be dimly 
lit when the function is off.
This will help you find the 
location of the buttons even 
on a dimly lit stage.

RD-300GX_e.book 65 ページ ２００８年２月１４日　木曜日　午後１時２６分