Roland AT-500 用户手册

 

Selecting and Playing Sounds

 

Selecting and Playing Sounds

 

If you’ve edited the harmonic bar settings in the screen, or if you’ve switched 
Registrations so that the Vintage Organ settings have changed, you can 
switch the Vintage Organ settings to the positions (settings) of the harmonic 
bars on the panel (p. 53).

 

When you press the Vintage Organ button, a vintage organ screen like the 
following will appear.

 

fig.01-24.eps

 

The screen will show the harmonic bars.
By touching the harmonic bars and sliding them, you can adjust the volume of 
each footage. The volume can be adjusted over nine steps (0–8).
When a harmonic bar is pulled out all the way (8), the volume is loudest. 
When it is pushed in all the way (0), there will be no sound.

 

Adds a vibrato effect to the sound.

 

Adds a chorus effect to the sound.

 

Touching

 

 

<

>

 

 cycles you through the available 

choices, which are: Upper Vintage screen, Lower Vintage 
screen, and Pedal Vintage screen.

 

The Vintage Organ screen will automatically close after it has 
been displayed for several seconds. If you touch <Hold>, the 
screen will remain displayed until you touch <Hold> once again.

When you touch the Vintage 
Organ screen and then change 
the settings, the screen is held 
in that condition.

By touching the screen and 
sliding your fingertip to the left 
or right (horizontally), you can 
adjust the volume of all 
harmonic bars.

It is not possible to apply both 
vibrato and chorus 
simultaneously.

AT-500_e.book 57 ページ ２００８年７月２８日　月曜日　午後４時１７分