Roland V-Synth GT 用户手册

 

fig.06d-21-ps.eps

 

The chorus of the Vintage vocoder is applied separately from the patch effect named Chorus.

 

200–800 Hz

Specifies the center frequency at which the low-frequency range will be 
boosted or cut.

 

-15– +15dB

Specifies the amount of boost/cut for the low-frequency range.

 

OFF, ON

Turns the high-frequency cut on/off. If you feel the sound is raspy, turn this 
switch on to make the sound smoother.

 

0–127

Adjusts the volume of Vocal Designer.

 

0–100

Specifies the attack time of the Vocal Designer sound relative to the mic input 
sound.

 

1–100

Specifies the release time of the Vocal Designer sound relative to the mic in-
put sound.

 

0–127

Specifies the level at which the consonants extracted from the mic input 
sound will be output.

 

4500–9000 
Hz

Specifies the frequency used when extracting the high-frequency components 
from the mic input audio as consonants. Components higher than the speci-
fied frequency will be extracted as consonants.

 

OFF, ON

This is an on/off switch for the chorus effect applied to the vocal sound.

 

0.05–10.0 Hz

Adjusts the modulation frequency of the chorus effect.

 

0–127

Adjusts the modulation depth of the chorus effect.

 

D:0:100E–
D:100:0E

Adjusts the balance between the vocal sound and the sound with chorus ap-
plied.

 

200–8000 Hz

Specifies the frequency at which the high-frequency range will be cut.

 

0.0–100 ms

Specifies the delay time until the chorus sound is heard.

V-Synth-GT_e.book 157 ページ ２００７年４月９日　月曜日　午後１時４６分