Roland V-Synth GT 用户手册

 

In this chapter, we will explain the procedures for:

• Sampling (p. 163)
• Editing samples (p. 178)
• Converting samples so the VariPhrase function can be used (Encoding) (p. 187)

 

A sampling template is something that holds a collection of settings for sampling (the setup settings, pre-effect settings, 
and metronome settings described below).
You can store eight different sampling templates. When you sample, you will always select one of these eight 
templates.
With the factory settings, eight sampling templates are preset.

 

 

Sampling templates are system settings (with the exception of some metronome parameters). They are remembered 
even when you turn off the power. If you wish to restore all eight sampling templates to the factory settings, perform 
the Factory Reset operation (p. 235).

 

The preset templates cover different input settings and pre-effect types.

 

Sample in mono from a mic. Connect a mic to the rear panel MIC IN jack.

 

Connect your portable audio player or similar device to the INPUT jack on the rear panel.

 

Sample a digital signal. Connect your audio device to the rear panel COAXIAL IN connec-
tor.

 

Play a sample on the V-Synth GT and sample the result. This is called “resampling.” For 
details on resampling, refer to p. 173.

 

Use the compressor pre-effect. The sample will be recorded from the rear panel INPUT 
jacks.

 

Use the limiter pre-effect. The sample will be recorded from the rear panel INPUT jacks.

 

Start sampling when a sequencer start (system realtime message: FA) is received. The sam-
ple will be recorded from the rear panel INPUT jacks.

 

Sampling from a PC USB Audio.

V-Synth-GT_e.book 163 ページ ２００７年４月９日　月曜日　午後１時４６分