Roland AT15 用户手册
53
Using the Registration Buttons
Automatically Registering When You
Switch Panel Settings
When the [Manual] button is ON (lit), all panel settings you make will be
stored automatically in the [Manual] button as they are made, thus updating
the Registration that had been previously saved. If you change to a preset
Registration [1]– [8] button, it is possible to return to the previous panel
settings by pressing the [Manual] button.
stored automatically in the [Manual] button as they are made, thus updating
the Registration that had been previously saved. If you change to a preset
Registration [1]– [8] button, it is possible to return to the previous panel
settings by pressing the [Manual] button.
fig.07-03
Assigning a Name to a Registration Set
When saving Registration sets, names like “REGIST-01 – 99” will be
assigned by default, but you can assign a name that will help you later to
identify the contents of the Registration set.
assigned by default, but you can assign a name that will help you later to
identify the contents of the Registration set.
fig.07-03
1.
Make sure that the disk drive contains a disk that was
2.
Press the [Registration] button (indicator lights).
3.
Press the [Load] button and the [Save] button
simultaneously.
Write
2
3
4
1
Manual
NOTE
The settings stored in the
[Manual] button returns to
the default settings while
the power is turned off.
[Manual] button returns to
the default settings while
the power is turned off.
2
3, 5
4
4
AT-15_e.book 53 ページ ２００５年１月２１日 金曜日 午後８時１４分