Roland FC-300 用户手册
58
Appendices
If other operational problems occur, first check by using the following solutions:
If this does not resolve the problem, then contact your dealer or a nearby Roland
service station.
service station.
The power doesn’t come on
• Is the specified AC adaptor (PSA series; sold separately) properly
connected?
Check connections again. Never use any AC adaptor other than one specified for
use with the FC-300 (p. 12).
use with the FC-300 (p. 12).
• Are the batteries dead?
Power not turning off
• Is there an RRC2 IN device connected?
MIDI messages are not transmitted/received
• Are the MIDI cables broken?
Try another set of MIDI cables.
• Is the FC-300 correctly connected to the other MIDI device?
Check connections with the other MIDI device.
• Do the MIDI channel settings of both devices match?
• Is the number pedal indicator flashing?
Program Change messages are not transmitted while the number pedal’s
indicator is flashing.
indicator is flashing.
Pressing a number pedal and selecting the number transmits the message.
• When you send messages from the FC-300, make sure the FC-300 is set to
the settings appropriate for sending data.
Check the
Expression pedal switch not switching on and off / Fails to
completely shut off the volume when used as a volume pedal
completely shut off the volume when used as a volume pedal
• Has the pedal gone out of adjustment?
Display is faint or flickering
Check the following settings.
Troubleshooting
The batteries that are supplied
with the unit is for temporary
use, intended primarily for
testing this unit.
with the unit is for temporary
use, intended primarily for
testing this unit.
When running on power
supplied by an RRC2 IN
device, the power is switched
on regardless of the position of
the POWER switch.
supplied by an RRC2 IN
device, the power is switched
on regardless of the position of
the POWER switch.
Although the FC-300’s EXP
pedals are adjusted for optimal
performance when shipped
from the factory, extended use
over time and under certain
usage conditions may result in
the pedals going out of
adjustment.
pedals are adjusted for optimal
performance when shipped
from the factory, extended use
over time and under certain
usage conditions may result in
the pedals going out of
adjustment.
FC-300_e1.book 58 ページ ２００７年４月２４日 火曜日 午前１０時１０分