Creative E-MU 用户手册

Basic Operations

Xboard

41



1. Sweep through all possible values without pressing harder either direction 

than you normally would. As you adjust, the display shows raw control val-
ues, reverting to the name of the control you are adjusting.

2. Press Enter to store the calibration, or press Home to back out of the pro-

cess. You are returned to the Calibration Standby mode.

3. Press Enter to calibrate another control, or Home to finish.



1. Sweep through all possible values without pressing harder in either direc-

tion than you normally would. As you adjust, the display shows raw con-
trol values, reverting to the word “Pit” (as in “Pitch Wheel”).

2. Let the Pitch Wheel spring back to its normal position in the center.
3. Press the illuminated Snap Shot button. The Edit LED should say “Ctr” (as 

in “Center”). You can repeat this step as many times as you want.

4. Press Enter. You are returned to the Calibration Standby mode.
5. Press Enter to calibrate another control, or Home to finish.



1. Press and hold the key(s) you want to use for calibration. Use the maximum 

amount of force you want for Aftertouch. The Edit LED alternates between 
the current key value and the word “Aft” (as in “Aftertouch”).

2. Press and hold the key(s) with the minimum amount of force at which you 

want the Xboard to begin sending Aftertouch messages. 

3. While holding the key(s), press the Snap Shot button. The Edit LED should 

say “tHr” (as in Threshold).You can repeat this step as many times as you 
want.

4. Press Enter to store the calibration, or press Home to back out of the pro-

cess. You are returned to the Calibration Standby mode.

5. Press Enter to calibrate another control, or Home to finish.

X Board.book  Page 41  Wednesday, April 12, 2006  10:44 AM