Roland 04672434 用户手册
148
Chapter 8 Parameter Guide SYSTEM
CONTROL
FC-300
Parameter/
Range
Range
Explanation
ASSIGN HOLD
This setting determines whether or not the values (positions) of the
D BEAM (H) or RIBBON CONTROLLER or the FC-300’s expression
pedals or control pedals or other controllers are to be reflected in the
sound as soon as a patch is called up.
D BEAM (H) or RIBBON CONTROLLER or the FC-300’s expression
pedals or control pedals or other controllers are to be reflected in the
sound as soon as a patch is called up.
ON
When a patch is called up, the controller val-
ues (positions) are applied, producing a
sound that reflects the controller settings.
ues (positions) are applied, producing a
sound that reflects the controller settings.
OFF
When a patch is changed, the sound set in
the patch is played, regardless of the
controller values (positions).
the patch is played, regardless of the
controller values (positions).
DIRECT EDIT
SYSTEM
The system parameter’s direct edit setting is
used. This applies the same settings to all
patches.
used. This applies the same settings to all
patches.
PATCH
The patch parameter’s direct edit setting is
used. This allows you to use different
settings in each individual patch.
used. This allows you to use different
settings in each individual patch.
DIRECT EDIT F1–F6
This assigns functions to the function buttons operable in the Play
screen and the [F1]–[F6] or F1–F6 knobs.
screen and the [F1]–[F6] or F1–F6 knobs.
TARGET PARAMETER
This selects the parameter to be changed.
Parameter/
Range
Range
Explanation
SYS EX MODE (System Exclusive Mode)
This sets the FC-300’s control method.
ON
When connected to the VB-99, the FC-300
automatically changes to System Exclusive
mode and operates in accordance with the
settings made with the VB-99. This is the set-
ting you should normally select.
automatically changes to System Exclusive
mode and operates in accordance with the
settings made with the VB-99. This is the set-
ting you should normally select.
You can control the FC-300 even
without matching the VB-99’s and FC-
300’s Device IDs.
without matching the VB-99’s and FC-
300’s Device IDs.
OFF
Select OFF when controlling the FC-300’s
with the FC-300 (manually).
with the FC-300 (manually).
BANK CHANGE
This sets the timing with which tones switch when patches are
changed with the FC-300.
changed with the FC-300.
IMMEDIATE
The tone changes immediately when the
FC-300’s
pedals are pressed.
WAIT NUM
Even after the FC-300’s
pedals are
pressed, the tone does not change until the
NUMBER is set.
NUMBER is set.
QUICK TUNER
This enables use of the FC-300’s number pedals to switch the Tuner
function on and off.
The Quick Tuner function is enabled only when the FC-300’s MODE
is set to SYS EX.
function on and off.
The Quick Tuner function is enabled only when the FC-300’s MODE
is set to SYS EX.
OFF
The QUICK TUNER function is not opera-
tional.
tional.
ON
The QUICK TUNER function is operational.
The TUNER function is alternately switched
on and off each time the currently selected
number pedal is pressed.
The TUNER function is alternately switched
on and off each time the currently selected
number pedal is pressed.
VB-99_e.book 148 ページ ２００８年８月１８日 月曜日 午後１時１０分