Roland 04672434 用户手册
38
Chapter 3 Global Device Settings (SYSTEM)
Set the clearance from the divided pickup to the bridge’s saddle for
each string.
each string.
*
This setting is not required when the GK PU TYPE is set to piezo-
type parameter.
1.
2.
Press PAGE [
] [
] to display Page 4.
3.
Rotate the F1–F6 knobs to set the clearance
for strings Hi C–Low B.
for strings Hi C–Low B.
Adjust the divided pickup sensitivity for each string.
1.
2.
Press PAGE [
] to display Page 5.
3.
Rotate the F1–F6 knobs to adjust the
sensitivity.
sensitivity.
Play each open string with the maximum force you’d use in an
actual performance, and set the sensitivity such that the meter
registers a level just before reaching the maximum level.
actual performance, and set the sensitivity such that the meter
registers a level just before reaching the maximum level.
*
If the large segments at the right end of the level meter appear, it
means the level is set too high. Lower the sensitivity setting.
*
Pressing [F1]–[F6] initializes each string’s value to 65.
*
Depending on the bass you use, the level meter may move to the
maximum level even when the sensitivity is set to the minimum
setting. If this occurs, adjust the clearance separating the divided
pickup and the strings so the distance is slightly greater than
specified.
4.
Play the Low B through Hi C strings with the
normal amount of force; if any string sounds
particularly loud, lower the sensitivity setting
for that string, and keep adjusting until the
differences in the strings’ volume levels are
minimal.
normal amount of force; if any string sounds
particularly loud, lower the sensitivity setting
for that string, and keep adjusting until the
differences in the strings’ volume levels are
minimal.
Setting the Gap Between the
Pickup and the Bridge
(PICKUP
Pickup and the Bridge
(PICKUP
↔
BRIDGE)
Settings
Explanation
0.0–50.0 mm
Specify the distance between the divid-
ed pickup and the center of each bridge
saddle.
The setting is disregarded when the GK
PU TYPE is set to piezo type parameter.
ed pickup and the center of each bridge
saddle.
The setting is disregarded when the GK
PU TYPE is set to piezo type parameter.
Bridge
Pickup
String
string 1
string Hi C
string Low B
string 2
string 3
string 4
string 3
string 4
Adjusting the Sensitivity for Each
String (SENS)
String (SENS)
Settings
Explanation
0–100
Adjusts the divided pickup input sen-
sitivity for each string.
sitivity for each string.
VB-99_e.book 38 ページ ２００８年８月１８日 月曜日 午後１時１０分